Filter
Top Products
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER
BEFORE TROUBLE SHOOTING YOUR FAN.
Trouble Shooting
TROUBLE PROBABLE CAUSE SUGGESTED REMEDY
1. Fan will not 1. Reversing switch in neutral position. 1. Make sure reversing switch position is
start. all the way to one side.
2. Fuse or circuit breaker blown. 2. Check main and branch circuit fuses or
circuit breakers.
3. Loose power line connections to the fan, 3. Check line wire connections to fan and
or loose switch wire connections in switch switch wire connections in the switch
. housing/light fitter. housing/light fitter.
2. Fan sounds 1. Blades not attached to fan. 1. Attach blades to fan before operating.
noisy. 2. Screws securing fan blade flanges 2. Check to make sure the screws which
to motor are loose. attach the fan blade flanges to the
motor are tight.
3. Wire connectors inside switch housing/light 3. Check to make sure wire connectors
fitter rattling. in switch housing/light fitter are not rattling
against each other or against the interior
wall of the switch housing/light fitter.
4. Screws holding flanges to blades are loose. 4. Tighten screws securely.
3. Fan wobbles 1. Screws securing fan blade flanges to 1. Check to be sure screws which attach
or shakes motor are loose. the fan blade flanges to the motor are tight.
excessively 2. Fan blade flanges not seated properly. 2. Check to be sure the fan blade flanges
seat firmly and uniformly to the surface
of the motor. If flanges are seated
incorrectly, loosen the screws and retighten.
3. Mounting plate/light fitter and/or ceiling 3. Tighten the mounting plate/light fitter
outlet box are not securely fastened. screws to the outlet box, and/or secure
` outlet box.
4. Fan blades out of balance. 4. Interchanging an adjacent (side-by-
side) blade pair can redistribute the
weight and result in smoother operation.
Maintenance
IMPORTANT CARE INSTRUCTIONS
For Your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
7
Using Your Ceiling Fan
1. Restore electrical power to the electrical box by turn-
ing the electricity on at the main fuse box or circuit
breaker panel.
2. Check the operation of the fan by gently pulling on the
fan switch pull chain.
Your fan model is equipped with a 4-position, 3-speed
fan pull chain switch. The operating sequence is as
follows:
3. All fans are shipped from the factory with the re-vers-
ing switch positioned to circulate air downward. If air-
flow is desired in opposite direction, turn your fan off
and wait for the blades to stop turning, then slide the
reversing switch to opposite position, and turn fan on
again. The fan blades will turn in the opposite direc-
tion and reverse the airflow.
4. Check the operation of the light fixture by gently
pulling on the light switch pull chain.
REVERSING
SWITCH
LIGHT SWITCH
PULL CHAIN
FAN SWITCH
PULL CHAIN
Figure 12
1st Pull – High
2nd Pull – Medium
3rd Pull – Low
4th Pull – OFF
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
WARNING
!
!