Filter
Top Products
2. Securely connect the motor orange wire to the
mounting plate/light fitter orange wire using wire
connector supplied. (Figure 5).
3. Securely connect the fan motor white wire and the
mounting plate/light fitter white wire to the supply
white (neutral) wire using wire connector supplied.
(Figure 5).
4. Connect the fan motor black wire and blue wire to
the supply black (hot) wire using wire connector
supplied. (Figure 5). Your fan is now wired to be
turned on and off from the fan switch. After connec-
tions have been made, turn leads upward and care-
fully push leads up into the outlet box.
5. Return to Step 3 of section "HOW TO HANG
YOUR CEILING FAN".
If you feel that you do not have enough wiring
knowledge or experience, have your fan installed
by a licensed electrician.
1. Connect the green grounding wire from the motor
bracket and the green wire from the mounting
plate/light fitter to the grounding conductor of sup-
ply (this may be a bare wire or wire with green col-
ored insulation). Securely connect wires with wire
connector supplied. (Figure 5.)
How To Wire Your Ceiling Fan
WHTIE
BLACK
GROUND
120V SUPPLY
BLACK
BLUE
WHITE
ORANGE
GREEN GROUND
WHITE
Figure 5
5
How To Put Your Ceiling Fan Together
1. Screw four 7-watt 120 volt light bulbs into the sock-
ets on the mounting plate/light fitter.
2. Install two 3/16-24 x 3/8” screws (several turns) into
screw holes on opposite sides of the mounting
plate/light fitter (Figure 6). Position the crystal glass
housing so that the keyhole slots in the crystal
glass housing engage with the two screws. Turn
the housing to the right so the keyhole slots rest on
the screws; tighten the screws. Install the other two
3/16-24 x 3/8” screws.
3/16-24 x 3/8"
SCREW
KEYHOLE SLOT
CRYSTAL
GLASS
HOUSING
Figure 6
3. Mount the blade flanges to the fan blades using
three 3/16-24 x 9/32” screws per blade (Figure 7).
Repeat for four remaining blades.
BLADE
FLANGE
FAN BLADE
(3) 3/16-24 x 9/32" SCREWS
Figure 7
To avoid possible electrical shock be sure electricity
is turned off at the main fuse box or circuit breaker
before wiring.
NOTE: If you are not sure if the outlet box is ground-
ed, contact a licensed electrician for advise for it
must be grounded for safe operation.
WARNING
!
To avoid risk of fire or shock check to see that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors except for
the ground wire. Do not operate fan until blades are
in place. Noise and fan damage could result.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flanges when installing the flanges, balancing
the blades, or cleaning the fan.
WARNING
!