Filter
Top Products
10
How to Wire
Your Ceiling Fan
If you feel that you do not have enough
electrical wiring knowledge or
experience, have your fan installed by a
licensed electrician.
CAUTION: To reduce the risk of
electrical shock, disconnect the electri-
cal supply circuit before installing the
fan, light kit or receiver.
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
!
WARNING
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
!
WARNING
1. If you are going to use an optional
Emerson Remote Control/Receiver or
Wall Control/Receiver to operate your
ceiling fan, wire your fan in accordance
with the Control/Receiver Owner’s
Manual. After wiring, return to step 4.
2. If you are going to control your fan
using two wall switches or optional
Emerson fan/light controls, you will
need a three-wire (with ground)
conductor cable between the ceiling
and wall outlet boxes. This will allow
you to operate the fan housing lights
and an optional Emerson Light
Fixture (if installed) from one
switch/control and the ceiling fan
from a separate switch. Refer to
Figure 14 and proceed as follows:
a. Connect the green grounding
lead from the hanger ball and the
green grounding lead from the
hanger bracket to the supply
grounding conductor (this may be
a bare wire or wire with green
colored insulation). Securely
connect wires with a wire
connector (supplied).
b. Securely connect the fan motor
white wire to the supply white
(neutral) wire using a wire
connector (supplied).
c. Securely connect the fan motor
black wire to the supply black
(hot) wire using a wire connector
(supplied).
d. Securely connect the fan motor
blue wire to the supply red (hot)
wire using a wire connector
(supplied).
e. After connections have been
made, separate the white and
green wires from the black, blue
and red wires.
f. Carefully turn the wires upward
and insert them up through the
open side of the hanger bracket
and into the outlet box. Push the
green and white wires into one
side of the outlet box; push the
black, blue and red wires into the
other side of the outlet box.
BP7305 Westfield 6/30/06 12:10 AM Page 10