Filter
Top Products
7
11. Slip the longest pull chain through the
hole in the large pendant (supplied)
(Figure 5). Then secure the pendant
by snapping the coupling (supplied)
onto the end of the chain. Secure the
small pendant (supplied) to the short
chain in the same manner as above.
12. Carefully place the partially
assembled ceiling fan on the lower
styrofoam pad, with the switch cup
assembly positioned in the opening
and the blade assemblies resting on
the outer rim of the styrofoam pad.
13. Remove the hanger ball by loosening
the setscrew in the hanger ball until
the ball falls freely down the downrod
(Figure 6). Remove th pin from the
downrod, then remove the hanger
ball. Retain the pin and hanger ball for
reinstallation in step 20.
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 6
14. Unscrew the two upper setscrews
(Figure 7) until they clear the inside of
the motor coupling. Then separate,
untwist and unkink the three 80”
motor leads. Route the motor lead
wires through the downrod. Align the
clevis pin holes in the downrod with
the holes in the motor coupling. Install
the clevis pin and secure with the
hairpin clip (Figure 7). The clevis pin
must go through the holes in the
motor coupling and the holes in the
downrod. Be sure to push the straight
leg of the hairpin clip through the hole
near the end of the clevis pin until the
curved portion of the hairpin clip
snaps around the clevis pin.
!
WARNING
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrews securely tightened. Failure to
verify that the pin and setscrews are
properly installed (as shown in Figure 7)
could result in the fan falling.
The hairpin clip must be properly
installed to prevent the clevis pin from
working loose. Pull up on the downrod
to make sure the clevis pin is properly
installed.
15. Tighten the two upper setscrews
(Figure 7) securely while pulling up on
the downrod.
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
16. Install four 7-watt (maximum)
candelabra bulbs (not supplied) in the
sockets on top of the motor housing
(Figure 7).
17. Place the center glass on the rim of
the fan motor and housing assembly;
make sure the center glass is seated
evenly in the housing flange
(Figure 8).
CLEVIS PIN
HAIRPIN
CLIP
MOTOR
COUPLING
SETSCREW (2)
SOCKET
7-WATT (MAX.)
CANDELABRA
BULB (4)
Figure 7
BP7305 Westfield 6/30/06 12:10 AM Page 7