Filter
Top Products
5
1. Mount the fan blades to the blade
flanges using three 10-32 x 1/2” pan
head screws and three #10 flat
washers (screws and washers
supplied) (Figure 1).
How to Assemble Your
Ceiling Fan
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blade flanges, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
!
WARNING
10-32 x 1/2"
PAN HEAD
SCREWS (3)
#10 FLAT
WASHERS (3)
FAN BLADE
BLADE
FLANGE
Figure 1
General
Your Emerson ceiling fan comes supplied
with a Fan/Light Wall Control which
consists of a wall control (transmitter) and
a remote control receiver mounted under
the ceiling cover. This system allows you
to regulate your ceiling fan speed and light
intensity.
NOTE: An optional Emerson Electric
SR100 Remote Control may also be
used to control your ceiling fan.
Ceiling Fan Procedures
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
!
WARNING
IMPORTANT: Before assembling your
ceiling fan, refer to sections “Setting
Operating Frequency of Wall Control
and Receiver” and “Installation of Wall
Control”, page 13. These sections
instruct you how to: a) Set the
operating frequency of the fan/light
wall control and the remote control
receiver; and b) Install the fan/light wall
control in the wall box. You will then be
ready to proceed with the assembly
and installation of your ceiling fan, as
follows:
NOTE: Take care not to scratch the fan
finish when installing the blade
assemblies.
2. Insert a blade flange into one of the
round holes in the mounting hub
(Figure 2). Insert one 5/32 x 9/16” pan
head screw (supplied) in one of the
flange mounting holes; do not tighten.
Install the second screw in the same
manner; tighten both screws securely.
Repeat this procedure for the other four
blade assemblies.
!
WARNING
To reduce the risk of personal injury, do
not bend the blade flanges when
installing the flanges, balancing the
blades or cleaning the fan. Do not insert
foreign objects between rotating fan
blades.
BP7306 Nottingham 6/19/06 1:00 PM Page 5