Filter
Top Products
8. Carefully turn partially assembled fan
over and place on top of the styrofoam,
resting on switch cover assembly.
6
9. Remove the hanger ball by loosening
the setscrew in the hanger ball until
the ball falls freely down the downrod
(Figure 4). Remove the clevis pin from
the downrod, then remove the hanger
ball. Retain the pin and hanger ball for
reinstallation in Step 14.
10. Separate, untwist and unkink the three
80” motor leads. Route the motor lead
wires through the downrod. Align the
clevis pin holes in the downrod with
the holes in the motor coupling. Install
the clevis pin and secure with the
hairpin clip (Figure 5). The clevis pin
must go through the holes in the motor
coupling and the holes in the downrod.
Be sure to push the straight leg of the
hairpin clip through the hole near the
end of the clevis pin until the curved
portion of the hairpin clip snaps around
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 4
Model No.: CF3600
FAN MOTOR ASSEMBLY
BLADE ASSEMBLY
INSTALLATION
SLOT
#8-32 x 5/8" FLAT
HEAD SCREW
(2 per flange/
blade assembly)
FLANGE
MOTOR HUB MOUNTING HOLE
Figure 2
Note: Be sure the flange screws on the
blade assembly are facing down for
correct installation into the motor hub.
3. Insert the blade flange into one of the
mounting holes in the motor hub
(Figure 2). Rotate the motor hub to
align the flange with the slot in the
motor assembly. Insert one #8-32 x
5/8” flat head screw (supplied) into one
of the flange mounting holes; do not
fully tighten. Install the second screw in
the same manner; tighten both screws
securely.
SWITCH COVER
ASSEMBLY
SWITCH COVER
CONNECTOR
MOTOR ASSEMBLY
CONNECTOR
SWITCH CHAIN
BUSHING
Figure 3
5. Securely engage the 3-pin connector
from the fan motor assembly with the
switch cover connector. The
connectors are keyed and must be
mated correctly before they can be
engaged (Figure 3).
6. Slide the pull chain through the chain
busing located on the side of the switch
cover.
7. Position the switch cover assembly
onto the fan motor switch cover adapter
plate. Align the switch cover assembly
switches with the clearance notches in
the motor assembly switch cover
adapter plate. Secure the cover using
three #8-32 x 1/4” flat head screws
(supplied).
NOTE: Do not pinch wires between the
fan motor assembly and switch cover
assembly.
NOTE: Take care not to scratch fan
housing when installing blades.
4. Repeat assembly instructions for the
remaining four blade assemblies.
BP7384 Camden, CF3600 2/18/09 2:57 PM Page 6