Filter
Top Products
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One light fixture assembly
c. Six fan blades
d. Six blade flanges
e. One ceiling cover
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One coupling cover
i. One light fixture mounting plate
j. One PAR 30 75-watt halogen flood lamp
k. One light adapter plate
l. One loose parts bag containing:
1. Nineteen 3/16-24 x 5/16” slotted Phillips head
blade screws
2. Nineteen M5 flat washers
3. One large wood pendant
4. One small wood pendant
5. Two couplings
6. Thirteen 1/4-20 x 1/2” Phillips oval head
flange screws
7. Three wire connectors
8. Two threaded studs
9. Two #8 lockwashers
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One 1/4” blade screwdriver One wire stripper
Three wire connectors (supplied).
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
3
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
Before assembly your ceiling fan, refer to “Wiring Your
Ceiling Fan” section for proper method of wiring your
fan (page 6). If you feel you do not have enough wiring
knowledge or experience, have your fan installed by a
licensed electrician.
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or
accessories not designated for use with this product
by Emerson Company could result in personal injury
or property damage.
10. Two knurled knobs
11. One clevis pin
12. One hairpin clip
13. Four 5/32-32 x 5/16” Phillips flat head screws
14. Three 3/16-24 x 1/4” Phillips round head screws
15. One two-sided foam tape
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
LOOSE
PARTS
BAG
FAN MOTOR
ASSEMBLY
LIGHT FIXTURE
ASSEMBLY
BLADE
FLANGES
LIGHT FIXTURE
MOUNTING PLATE
COUPLING
COVER
CEILING
COVER
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
HALOGEN
FLOOD
LAMP
FAN
BLADES
LIGHT ADAPTER
PLATE
WARNING
!
WARNING
!
WARNING
!