Electrolux Z7040 Air Cleaner User Manual


 
OPERATING INSTRUCTIONS
1. Air outlet grills
2. Reset button for filter replacement
3. Audio Sensor
4. Display
5. Fan Speed Control
6. Air inlet grills
5
4
3
2
1
7
6
8
11
910
7. Pre-filter Door
8. Carrying Handle
9. Power Cord
10. Compartment for unused cord
11. Top cover release button (On both
sides of air cleaner.)
CONTROLS
Automatic Mode A This position adjusts the fan
speed to the noise level in the room.This automatic
mode senses room noise to increase or decrease
fan speed. This mode is a good choice when
entertaining.
Automatic Mode B This position adjusts the fan
speed to the degree of air contamination in the room.
Manual Mode C This position provides a manual
setting for the fan speed. O is off, 3 is highest speed.
A
B
3
MODEL TYPE SERIAL NO.
VOLTS AMPS. HERTZ
SERVICE INFORMATION: USA1-800-282-2886
Canada 1-800-282-2886
Rating Plate
The model, type, and serial number are
indicated on the rating plate located on the
back of the cleaner. For prompt and complete
service information, always refer to these
numbers when inquiring about service.
Model & Type______________________Serial No._________________________
GENERAL INFORMATION (continued)
C
USAGE
All models are designed to run continuously with the fan speed set to (1). When required,
they can be run at higher speeds (2) and (3).
The best results are achieved by leaving the air cleaner on around the clock. (it uses
less power than most light bulbs).