Filter
Top Products
Routine Maintenance (continued)
Installing New Dustbag Ref: ES82
(Alternate bag is E82)
7
Make sure dirt inlet goes
completely into dustbag and
bag is pushed completely
back into place. Tuck excess
bag into cleaner.
remove install
Replace dustbag cover on unit.
CAUTION: Dustbag cover
cannot be closed unless
the dustbag is installed
properly.
2. Remove the two screws from the top of the hood.
3. Lift hood to remove.
4. Lift left end of brushroll.
5. Remove and discard belt.
6. Place new belt around motor shaft.
7. Place new belt around brushroll pulley.
8. Align left end cap with base. Push end cap securely into
place.
9. Pull right side of brushroll to stretch belt. Secure right end
cap into base.
IMPORTANT
10. Rotate brushroll by hand two full rotations to properly
position belt.
11. Place hood back on cleaner. Replace and tighten two
screws.
12. Return vacuum to upright position.
Periodic Maintenance
CAUTION: Turn off the switch and unplug the electrical
cord before periodic maintenance. Never
operate the vacuum cleaner without the
dustbag or lter assembly in place.
Brushroll
The brushroll turns as it sweeps and combs the carpet pile.
Remove hair and threads from the brushroll so it continues
brushing the carpet. To maintain the most efcient cleaning,
the bristles must touch the carpet.
Brushroll Belt (Ref: ZE090)
The brushroll belt turns the brushroll to agitate, sweep, and comb the
carpet pile. Check the belt regularly to be sure it is in good condition.
Replace the belt if it stretches, cracks or loses tension. Cut away
any hair or threads wound around the brushroll or the belt pulley
because the buildup could cause the belt to rotate unevenly.
WARNING: Care should be taken when vacuuming rugs
to ensure that edges and fringes do not snap
the drive belt and stop the rotation of the
brushroll.
Fold dustbag cardboard ap
at top back.
1. Lower handle to oor to change belt.
How To Replace Brushroll Belt