GENERAL INFORMATION
Automatic Suction Shut-Off
NOTE: Use the vacuum in the upright position. If the cleaner should tip, the automatic suction shut-off turns off the
suction.
The automatic suction shut-off functions when the tank is full of liquid. As the tank fills, the ball float (inside the cage) rises until
it seats itself against the motor inlet. This shuts off the suction causing the motor sound to become higher in pitch. When this
happens, empty the tank.
The automatic suction shut-off also functions if the cleaner tips over. To continue use, turn cleaner off and set it upright. Wait a
few seconds to allow motor to come to a complete stop so the ball drops. Restart the motor.
Use this vacuum for wet pickup only.
Service Information
The instructions in this booklet serve as a guide to routine maintenance. For additional service information, telephone our toll
free number for the nearest Sanitaire Authorized Warranty Station. You should know the model, type and serial numbers
when you call:
USA: 1-800-800-8975
Mexico: 5670-6169
Canada: 1-800-800-8975
If you prefer, you can write to Electrolux Home Care Products North America, Service Division, 807 North Main Street, Bloomington,
Illinois 61701, USA. In Canada, write to Electrolux Home Care Products Canada, 866 Langs Drive, Cambridge, Ontario N3H
2N7. Refer to The Sanitaire Warranty for complete service information.
DO NOT OIL the motor at any time. Bearings have a seal and are permanently lubricated.
Rating Plate
The model, type and serial numbers are on the rating plate, located on the back of the
unit. For prompt and complete service information, always refer to these numbers when
inquiring about service.
Model and Type:_________________________
SERVICE INFORMATION: 1-800-800-8975
MODEL TYPE SERIAL NO.
VOLTS AMPS. HERTZ
Serial No._______________________________
3
IDENTIFY PARTS OF CARPET CLEANER
1. Handle
2. Hose Inlet
3. Recovery Tank Lid
4. Solution Tank Lid
5. Drain Outlet
5a. Drain Outlet Diverter
6. Solution Hose Connection
7. Rear Wheels
8. Vacuum Switch
8a. Pump Switch
9. Power Cord
10. Extension Cord
11. Suction hose
12. Solution hose
13. Cleaning Nozzle (12" Wand)
14. Solution Trigger
15. "T" Handle