Electrolux IH 18 Water Heater User Manual


 
13
Electrical connection
The electrical connection should only ever be made after the water is
connected! The appliance is only suitable for a fixed connection of
380 V 3 ~ (three-phase current) .
The appliance must be connected to the protective conductor.
Important note: The wiring must be arranged so that the appliance can be
de-energised (disconnected from the electricity supply) before any intervention
involving the fuses being unscrewed, the automatic safety devices being
switched off, or similar measures being taken (isolating gap width of at least
3 mm).
Electrical connection terminal (3)
factory-prefitted.
Cut out cable inlet opening (1).
Slide flexible inlet bush (2) over
connection cable, insert it through the
back wall opening, and screw fixing
strap under connection terminal (4).
Mains connection on top
Mains connection lead
The connection cable must project from the wall
over an insulated length of at least 20 mm.
1
2
3
max.10
4
20
150