Filter
Top Products
6 7
19 20
21 22
23 24
25 26
Getting the best results
Use the nozzles as follows:
Carpets: Use the combination oor nozzle with the
lever in position (19).
Hard oors: Use the combination oor nozzle with the
lever in position (20).
Wooden oors: Use the parquet nozzle* (21).
Upholstered furniture and fabrics: Use the upholstery
nozzle* (22) for sofas, curtains, lightweight fabrics etc.
Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the feather duster* (23).
Crevices, corners, etc.: Use the crevice nozzle* (24).
Using the turbo nozzle*
25/26 Ideal for carpets and wall-to-wall carpeting to
remove stubborn u and pet hairs.
Note: Do not use the turbo nozzle on skin rugs or carpet
fringes. To avoid damaging the carpet, do not keep the
nozzle stationary whilst the brush is rotating. Do not pass
the nozzle across electric cables, and be sure to switch off
the vacuum cleaner immediately after use.
* Certain models only.
* Certain models only
Emptying and cleaning the dust container
CycloneXL’s dust container must be emptied when it
is full.
27 Pull the release button at the rear of the vacuum
cleaner.
28 Lift the dust container out.
29 Open the lid of the dust container by pressing the
release button on the right.
30 Empty it over a wastepaper basket. Put the dust
container back (31) and press the rear part of the
container until it clicks into place.
32 Every now and then the dust container should be
cleaned. Remove lids at both ends and rinse the
container in water or machinewash it. Remove
particles that may be stuck in the cone.
32
31
28
27
29
30