Filter
Top Products
24
Electrical connection
Details on mains voltage, type of current and the fuses required should
be taken from the type plate. The type plate is fitted near the loading
aperture (see “Machine description” section).
Changing door stop
1
Warning! The door stop may only be changed by a qualified person. If
necessary, please contact our after-sales service or your specialist deal-
er.
Warning! Before changing the door stop, disconnect the mains plug;
with a permanent connection: fully unscrew or deactivate the fuse.
1. Open loading door
2. Unscrew hinge A from the front of
the machine and take off the load-
ing door.
3. Use a thin screwdriver to pry off
cover plates B and C.
4. Use an appropriate tool and exert
pressure to unfasten locking block D
from the snap-on fixture, take out
and reinsert on the other side, hav-
ing rotated the block through 180°.
5. Unscrew hinge A from the loading door, rotate through 180°, reinsert
on the opposite side and screw down.
6. Reinsert cover plates B and C on the opposite site having first rotated
them through 180°.