Electrolux 5540 Vacuum Cleaner User Manual


 
20
Drying results unsatis-
factory.
Wrong programme selected.
Select a different programme
the next time you dry (see
“Overview of programmes”
section).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
Incorrect volume of laundry.
Observe recommended load-
ing volumes.
Ventilation slots in base area
covered up.
Uncover ventilation slots in
base area.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Loading door does not
close.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Install fine strainer and/or
snap large mesh filter into
place.
When pressing the
& SPECIAL CARE but-
ton, the corresponding
indicator flashes sever-
al times.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Turn the programme knob to
O OFF. Set the programme
again.
Programme inactive,
o EMPTY WATER dis-
play illuminated.
Condensate tank is full.
Empty condensate tank, then
start programme with
START/PAUSE button.
Drying cycle ends
shortly after pro-
gramme starts. E END
display illuminated.
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Select time programme or
higher drying level (e.g.
N INTENSIVE DRY instead of
» STORAGE DRY).
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete“).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged
with lint.
Clean heat exchanger.
& SPECIAL CARE button
pressed and load volume too
big.
& SPECIAL CARE is only suita-
ble for use with loads of up to
2,5kg!
Load volume too big. Reduce load volume.
Laundry insufficiently pre-
drained.
Laundry must be adequately
pre-drained.
Problem Possible cause Remedy