Filter
Top Products
percentage (within the range of 1% to nonstop burst) by
means of Up / Down keys. To adjust timer setting, go
into Timer option. Cycle through Interval (within the
range of 1 to 900 seconds), Duration (within the range
of 1 to 200 seconds), and Volume (within the range of
1% to nonstop burst) by means of Up / Down keys. Use
Enter (Volume) Key to select each option and make
changes as desired. To turn off the heater and fan, go
into Heat & Fan option. Use Enter (Volume) Key to
confirm the selection. Use On/Off (Manual) Key to turn
it on.
2.Press the Timer key to activate the timer function.
The display shows the adjusted interval and the device
counts the seconds down to "0". After that, the fog
emission is triggered at the volume adjusted under
"Timer Out". The duration depends on the settings
adjusted under "Duration Set". If you wish to deactivate
the timer function, press the Timer key once more.
3.Press the Volume switch for immediate triggering of
the fog emission at the volume adjusted under "Volume
Out". Press the Volume switch once more in order to
stop the fog emission.
4.Press the Manual key for immediate triggering of the
fog emission at 100 % volume. Let the Manual key loose
in order to stop the fog emission.
! X-20: DMX Interface module. Please refer to the section
on Page 8 titled X-20 DMX Module Settings.
7