Filter
Top Products
18
NOTE
Never use a higher speed setting than necessary to perform a task.
Remember, the higher the engine speed, the louder the blower noise.
Be Smart - be a good neighbor.
4. Set engine speed with throttle position knob (F).
5. Place shoulder harness over right shoulder. Hold and guide Shred
'N' Vac
®
with both hands clasped firmly on side and top handles.
Keep unit to your right side.
OPERATING BLOWER
WARNING DANGER
Always wear safety glasses, hearing protection and a face filter
mask or serious personal injury may result. .
Do not point the blower pipe in the direction of people or pets.
Never operate unit without housing cover grill secured by thumb
nut otherwise bodily harm may result.
Read the Safety Section carefully.
IMPORTANT
To avoid engine damage due to over revving, do not block blower
pipe.
1. Use only during appropriate hours.
2. Allow the engine to warm up at a fast idle for a few minutes.
3. Set engine speed with throttle position knob (F). Rotate lever
forward for lower speed; back for higher speed.
NOTE
The ES-2100 can be run at any speed from 2500 RPM to 7500 RPM
once the engine has broken in (approximately after 3 fuel tanks).
The ES-2400 can be run at any speed from 2500 RPM to 8000 RPM
once the engine has broken in (approximately after 3 fuel tanks.)