Filter
Top Products
17
S
HRED
'N' V
AC
®
O
PERATOR
'
S
M
ANUAL
STOPPING ENGINE
1. Release throttle trigger (E) and allow engine to idle for a minute.
2. Move stop switch (A) to "STOP" position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
OPERATING SHRED 'N' VAC
®
WARNING DANGER
Always wear safety glasses, hearing protection and a face filter
mask or serious personal injury may result.
Do not point the blower pipe in the direction of people or pets.
Read the safety section carefully.
IMPORTANT
To avoid engine damage due to over revving, do not block vacuum
pipe.
1. Use only during appropriate hours. Check your local ordinances.
2. Make sure bevel at the end of tube faces downward.
3. Allow the engine to warm up at a fast idle for a few minutes.
NOTE
The vacuum can easily be controlled from a mild vacuum for small
leaves to maximum suction for larger leaves and twigs. For maximum
shredding a higher speed setting is required.
The ECHO ES-2100 can be run at any speed from 2500 RPM to 7500
RPM once the engine has broken in (approximately after 3 fuel
tanks).
The ECHO ES-2400 can be run at any speed form 2500 RPM to 8000
RPM once the engine has broken in (approximately after 3 fuel
tanks.)