Dyson DC18 Vacuum Cleaner User Manual


 
Polarization instructions
To reduce the risk of electric shock, this appliance has a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.
Assembly
Ensure hose is straight when inserting wand.
Usage and carrying
Caution
This machine is intended for domestic use only. Fine dust such as plaster dust
or flour should only be vacuumed in very small amounts.
Use the carry handle to lift the machine.
Do not press the cyclone release button while carrying the machine or it could
fall and cause injury.
Ensure the cyclone is secured to the machine.
Do not shake the machine while carrying or it could fall and cause injury.
Keep hair and loose fabrics away from wand cap when machine is on.
When finished cleaning, push machine into an upright position to drop stabilizers.
Ensure wheels are fully locked in place before releasing the cleaner.
Brushbar controls
The brushbar will re-set to “ON” each time you start the machine and put it
in the cleaning position.
To turn the brushbar off, put the machine in the cleaning position and press
the brushbar on/off button.
Ensure the machine is in an upright position before adjusting the setting.
Turn the brushbar off when vacuuming bare or delicate flooring, rugs, and carpets.
Consult your flooring manufacturer’s recommended instructions before vacuuming
and caring for your flooring, rugs, and carpets. Some carpets will fuzz if a rotating
brushbar is used when vacuuming. If this happens, we recommend vacuuming in
bare floors mode and consulting with your flooring manufacturer.
The brushbar will automatically stop if it becomes obstructed.
If the brushbar stops during use, please refer to the blockages section.
TIP: The brushbar will not turn until you tilt the handle backwards to begin
vacuuming.
Wand release/Using tools
Ensure machine is in upright position before using tools.
To protect your floors, the brushbar will not rotate when the machine is in an
upright position.
Ensure hair and loose clothing are kept clear of wand cap when machine is
switched on.
Ensure wand cap is closed, unless using with tools.
Powerful suction can cause the hose to ‘pull back’ – please take care when
cleaning stairs.
To avoid personal injury and to prevent the machine from falling when cleaning
stairs, always place it at the bottom of the stairs.
Do not use your vacuum cleaner outdoors or on wet surfaces. Vacuum may be used
inside a garage only with the Model 08909 Dyson Car Cleaning Kit accessories. If
used in a garage, care should be taken to wipe the soleplate and wheels with a dry
cloth after vacuuming to clean off any sand, dirt, or pebbles which could damage
delicate floors.
For your safety, when the hose is fully extended, grasp firmly by the hose, not
the tool.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY
18860_OPS_MANUAL_UPDATE_FOR_LEGAL_COPY_DC18_5YR_QUICK_AMEND.qxd 5/11/07 10:34 Page 3