Dyna-Glo KFA400DGD Gas Heater User Manual


 
12
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
G.) FUEL FILTER
CLEAN TWICE PER HEATING SEASON OR AS NEEDED.
Tank Fuel Filter
Pump Fuel Filter
- Remove fan guard.(See page 11)
- Unscrew (C.W) filter bottom from filter top
with adjustble pliers.
- Remove fuel filter, gasket, magnet from filter
bottom.(See Figure 15)
- Wash filter bottom with clean kerosene .
- Wipe inside of filter bottom dry with clean cloth.
- Wash Fuel filter in clean kerosene.
- Remove dirt attached magnet.
- Put clean magnet, fuel filter and gasket back in
filter bottom.
- Tighten firmly.
FILTER BOTTOM
MAGNET
FUEL FILTER
GASKET
FILTER TOP
Figure 14. Remove Tank Fuel Filter
Figure 15. Fuel Pump Filter
- Remove fan guard (See Figure 11).
- Disconnect fuel line (B) from pumpand pump
fuel filter assembly with3/8” wrench (See Figure
14).
- Remove two screws that fix bracket-filter to shell
lower and remove bracket-filter.
- Carefully pry fuel filter loose from fueltank with
flat end of screwdriver.
- Wash fuel lines and fuel filter with clean
kerosene.
- Replace fuel filter into fuel tank.
- Replace bracket-filter to shell lower.
- Connect fuel lines (B) to pump and pump fuel
filter assembly.
- Reinstall fan guard.
SHELL LOWER
BRACKET-FILTER
SCREW
PUMP
PUMP FUEL FILTER ASSEMBLY
FUEL LINE(B)
FUEL FILTER