Filter
Top Products
11
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
F.) FUEL LINES
TIGHTENING FUEL LINES ANNUALLY OR AS NEEDED.
- Remove upper shell (See page 9).
- Use 1/4” wrench and tighten fuel lines(A) at solenoid valve
and at pump. (See Figure 12)
- Remove fan guard (See Figure 13)
- Use 3/8” wrench and tighten fuel lines (B) at pump, pump fuel filter assembly.
- Reinstall fan guard.
E.) PHOTOCELL
CLEAN PHOTO CELL ANNUALLY OR AS NEEDED.
- Remove upper shell(See Page 9)
- Remove photocell from photocell Bracket and disconnect photocell from connector.
- Clean photocell lens with cotton swab.
- Inspect photcell lens for damage. If damaged, replace photocell.
PHOTOCELL BRACKET
PHOTOCELL LENS
INSTALL PHOTOCELL
1)INCORRECT
2)CORRECT
PHOTOCELL
CONNECTOR
BURNER HEAD
FUEL LINE(A)
FUEL LINE(A)
FUEL LINE(B)
SOLENOID
VALVE
FAN GUARD
SCREW
FLAT WASHER
Figure 11. Clean photocell Lens
Figure 12. Tighten fuel line Figure 13. Remove Fan guard