Filter
Top Products
NOTE: DO NOT ATTEMPT TO CLEAN THE NATURAL COOL MOISTURE™ FILTER WITH
ANY CHEMICAL SOLUTIONS, DOING SO WILL DAMAGE THE FILTER.
If the Natural Cool Moisture™ filter appears to be clogged by hard water or mineral
deposits, soak it in a sink full of cool water for 10 minutes. DO NOT SQUEEZE OR WRING
OUT THE NATURAL COOL MOISTURE™ FILTER. Always place it back in the humidifier wet.
There are many steps you can take each time you fill your humidifier to make sure you get
the most life out of our Natural Cool Moisture™ filter.
1. To prevent mineral deposits, use Honeywell
®
humidifier water softener, part no. HAC-102,
each time the Water Tank is refilled.
2. Treat the Natural Cool Moisture™ filter with care. DO NOT squeeze or wring it out, DO
NOT clean the filter using any chemical solution.
3. Always purchase Honeywell
®
Brand Natural Cool Moisture™ filters (HC-888) as the fan
motor of this humidifier and the Natural Cool Moisture™ filter are designed to function
efficiently as a set. Using any other filter could damage the motor or impair the
humidifier’s performance.
4. Be sure to empty water from the Water Tank and Base when not in use.
PROLONGING THE LIFE OF THE FILTER AND
MAINTAINING A CLEAN HUMIDIFIER
• Follow weekly CLEANING instructions when the humidifier will not be used for at least one
week or more, or at the end of the season.
• At the end of the season, remove and throw away the filter; do not store with a used filter.
• Dry the humidifier completely before storing. DO NOT store with water inside the Base or
Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
• Before next use, remember to install a new filter and clean the humidifier.
END-OF-THE-SEASON CARE AND STORAGE
035-00326-004_R1 DCM-200 OM 5/11/04 10:51 AM Page 7