Filter
Top Products
NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall for proper
air flow (Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring.
Kaz will not accept responsibility for property damage caused by water spillage.
• Remove the water tank by grasping the handle and pulling straight up (Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2). Remove the Natural Cool
Moisture™ filter from the base before filling the unit with water. Soak in a sink full of cool
water to help reduce mineral build up and place back in the humidifier while wet. DO
NOT SQUEEZE OR WRING OUT THE NATURAL COOL MOISTURE™ FILTER. To help
extend the life of your filter repeat this step each time you fill your humidifier.
• Turn the water tank upside down so that the fill cap is facing up; unscrew the fill cap by
turning it counter-clockwise and set aside.
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is not necessary as the
water is filtered by the Natural Cool Moisture™ filter.
DO NOT USE HOT WATER. Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise . DO NOT OVER TIGHTEN.
Turn the water tank right-side up.
Fig. 1
Wall
6”
Lift
Fig. 2 Fig. 3
SET UP
FILLING
035-00326-004_R1 DCM-200 OM 5/11/04 10:51 AM Page 4