Drolet 36C03U TYPE 139 Indoor Fireplace User Manual


 
REFRACTORY PANELS INSTALLATIONS :
1. Remove the front glass as described on page 11.
2. Remove the logs from the firebox.
3. Install the two sides refractory panels and pull them forward as mush as possible
to help insertion of the back panel.
4. Place the back refractory against the back of the firebox.
5. Push the side refractory against the back to hold it in place.
6. Put the logs back in place.
7. Screw the glass back on.
EMBERS KIT INSTALLATIONS :
Three small plastic bags are supplied with your unit. One bag contains vermiculite to
simulate ashes in the firebox, another contains lava rocks to simulate coals and the other
one contains fibreglass mat which, when glowing red, resembles hot embers.
1. Place some vermiculite and lava rock on the top of the burner, keeping it well
clear of any gas ports ( holes where the gas comes out of the burner ) and
combustion air intake holes.
CAUTIONS : Blocking gas ports with vermiculite will result in poor light up
performance and delayed ignition.
2. Place four or five pieces of fibreglass mat with sizes of approximately 1” on top
of the front gas ports. Place two or three pieces over each of the back gas ports.
Make sure not to put to many pieces, this would result in altered flame and
possible carbon deposition.
16