Filter
Top Products
07-01583B 06-07 Copyright 2007 Dri-Eaz Products, Inc. 4
injury. Always place a strap around the top of the EB1400
and secure it to the Unimover or hand truck before
attempting to lift the unit.
3. Store with left side of unit against the wall and keep
upright while transporting. Secure into place with a strap.
NOTICE! Store securely to avoid any damaging impact to
internal parts.
MAINTENANCE
WARNING! Turn off and unplug unit before cleaning or
servicing.
BEFORE EACH USE
1. Inspect Power Cord
Inspect power cord for cuts, fraying or damage; do not use
if damaged.
WEEKLY MAINTENANCE
Inspect Front Filter
Slide duct ring adapters for outlet D off to remove front filter for
cleaning. Slide out the filter and inspect for damage or
excessive dirt. Use a clean 3M™ HAF Filter (below). Replace
filter every four months or earlier if necessary. For Parts and
Service call your local distributor, or the Dri-Eaz Service
Department at 800-932-3030 or (360) 757-7776.
Use Clean 3M HAF Filters
Keep clean filters in the unit at all times to keep out dust and
protect internal components. Vacuum filter up to 3 times and
reuse. Note: The two filters used for the unit are the same type
but different sizes. Be sure the appropriate size is installed.
MONTHLY MAINTENANCE
1. Exterior Inspection
Inspect exterior components and make sure they are
properly installed. Listen to the unit for abnormal sounds.
For Parts and Service call your local distributor, or the
Dri-Eaz Service Department at 800-932-3030 or (360)
757-7776.
2. Clean Exterior
Clean the housing with a damp cloth. Bring back the
original shine with a vinyl cleaner/polish like those used on
automobile plastics.
3. Inspect Back Filters
The second set of filters is in the back of the unit on the
condenser side and may only require cleaning periodically
(every 3-6 months depending on the cleanliness of the air
ducted or drawn into the condenser inlet). To access these
filters, use a 3/8” socket wrench to remove the 6 ¼-20
bolts holding the back cover in place. If you need further
assistance, contact the Dri-Eaz Service Department at
800-932-3030 or (360) 757-7776.
Condenser Side Filter Location
SPECIFICATIONS
Model F374
Weight 185 lbs. (84.1 kg)
Dimensions (HxDxW) 45" x 25" x 31"
(114.3 cm x 63.5 cm x 78.7
cm)
Amperage 11.7 amps
BTU’s (cooling capacity) 10,120 BTU/h
CFM 470 Evaporator air stream
750 Condenser air stream
Power 1265 W (1.695 HP)
Filters
3M HAF Filter
Cord Length
20 ft. (6.1 m)
Construction
Rotomolded shell
Safety ETL listed to UL 474 and
CSA C22.2 #92-1971
Specifications are subject to change without notice.
Some values may be approximate.
FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR,
or the Dri-Eaz Service Department at 800-932-3030 or (360)
757-7776. www.dri-eaz.com
Back filters