Filter
Top Products
Page 8
anchor or drilled hole.
8. Tighten both screws until heater is firmly secured to wall. Do not over tighten.
1. Clearance requirements from surface of carpeting, tile or other combustible
material(See Figure 1.).
Wall Mounted & Floor Mounted With Base Provided
Rear 0 Inches
Sides 13 Inches
Top 36 Inches
Floor 2 Inches
NOTICE:
Maintain the minimum clearances shown in Figure 1, but you can provide
greater clearances from floor, ceiling and adjoining wall.
2. After mounting brackets are installed, hang heater on mounting brackets in holes
provided at the rear of heater(See Figure 7.).
Figure 5
Figure 6
20"
Min.
16"
1.18"
18"
Min.
Adjoining Wall
30,000 BTU/Hr Model
Floor
20"
Min.
16"
1.18"
14 1/4"
Min.
Adjoining Wall
18,000 BTU/Hr Model
Floor