Filter
Top Products
Page 13
7. If pilot goes out, repeat steps 3 through 6. This heater has a safety interlock
system. Wait one(1) minute before relighting pilot.
8. When the pilot is lit, turn gas control knob to ON. Turn thermostat control
knob counterclockwise to desired heating level. The main burner
should light. Set control knob to heat level between 7 and 1.
CAUTION : Do not try to adjust heating levels by using the manual shutoff valve.
TURNING OFF GAS TO HEATER
Shutting Off Heater
Turn control knob clockwise to the OFF position.
Shutting Off Burner Only (Pilot stays lit)
Turn control knob clockwise to the PILOT position.
THERMOSTAT CONTROL OPERATION
Thermostat has a sensing bulb and a temperature control knob. The thermostat used
on this heater senses the room temperature and turns the burner on and off.
At times the room may exceed the set temperature.If so, the burner will shut off.
The burner will cycle back on when room temperature drops below the set
temperature.
Pilot Burner
Ignitor Electrode
Thermocouple
1
2
3
4
5
6
7
PILOT
NO
OFF
IGN