Filter
Top Products
7
❖❖
❖❖
❖
English
L-2245
Figure 4. Bottom View of Carry-On
Figure 5. The Carry-On positioned in the hatch of a boat without the hatch bag.
Hatch Pad
Air Filter
Leg
Condensate
Drain
Air
Intake
Vents
Cam
"D"
Ring
Foot (Soft)
Optional
3/8"
Flexible
Drain
Tube
(See Installtion
Instructions #5)
use the alternative batten pockets, you must cut the battens
to size. A more weathertight seal can be achieved if you
adapt the hatch bag to your boat using a Velcro® brand
fastener, or snaps. Consult your marine dealer or canvas
shop if you need help.
4. Level unit with adjustable cam and leg. Adjust the leg until
the indicator bubble is away from the side of the level. It is
not necessary to exactly center the bubble. If your hatch
location is such that the Carry-On cannot be leveled with the
leg fully extended, you must provide an additional means of
support to allow the degree of leveling described. Under no
circumstances should the Carry-On be operated more than
10 degrees off level, since this could cause loss of proper
lubrication to internal parts and void the warranty (See
Figures 3a & 3b).
5. A condensate drain is located under the unit (See Figure
4) in a position such that water removed from the air is
allowed to drain onto the deck. Should you desire to drain
this water to another area, a 3/8" I.D. (See Figure 4) hose fits
the condensate drain.
NOTE: The hose must be routed downhill continually with no
"up" loops or air traps.
6. You are now ready to operate the Carry-On. Follow the
operating instructions.
Level
Air Intake VentsHandle
Groove
Hatch Pad
Leg
"D" Ring
Location
Return Air
Discharge Air
Exhaust Vents
Groove