Filter
Top Products
6
4800 SERIES VACUFLUSH TOILETS
PROPER BOWL CLEANING
For stubborn bowl stains, use SeaLand
®
Toilet Bowl Cleaner (Fig. A).
It’s manufactured especially for use with all SeaLand toilets. In certain
locations where water is hard, a build-up of lime may dull the toilet bowl
nish. Restore the shine with this SeaLand cleaner. If you cannot nd it
in your area, contact Dometic for your nearest dealer. If the cleaner is not
available, you can also use most non-abrasive bathroom and toilet bowl
cleaners (Bar Keeper's Friend
®
spray cleaner, Clorox
®
toilet bowl cleaner,
SaniFlush
®
toilet bowl cleaner, etc.). Please follow label instructions.
To avoid damaging the Teon
®
-coated seal,
DO NOT USE
:
– abrasives (Comet
®
, Soft Scrub
®
cleansers etc.)
– caustic chemicals (Drano
®
clog remover, etc.)
– lubricants and cleaners containing alcohols or petroleum distillates
(Pam
®
cooking spray, Pine-Sol
®
cleaner, WD-40
®
lubricant, etc.).
Fig. A
EXTENDED PERIODS OF NON-USE –
CLEARING DISCHARGE LINES
Toilet system sanitation hoses should be cleared if toilet will not be needed for an extended period of time (more
than two weeks).
1. Fill toilet bowl with water and add 4 oz. (120 ml) of biodegradable laundry detergent (should
NOT contain
bleach).
2. Open ush ball in Service Mode (see directions above). Hold the Add Water switch down for about two
minutes. Release the Add Water switch and return the Service Mode switch to the Normal position.
3. Turn off water supply to toilet.
4. Flush the toilet without water, allowing the vacuum pump to shut off after the ush. Repeat three times. (This
procedure will minimize any remaining water in the sanitation hoses.)
5. Turn off power to the vacuum pump.
6. Completely pump out holding tank.
If system will be subjected to freezing temperatures, please follow above procedure, then winterize system as
described on next page.
TURN OFF ELECTRICITY AND WATER TO TOILET IF IDLE FOR LONG PERIODS OF TIME
If people will not be using the boat for a long time (vacation, maintenance, off-season, etc.), or in the event of a
long electrical power interruption, electrical power and water supply to the toilet and vacuum generator should be
shut off.
SERVICE MODE
SERVICE MODE
.
To clean toilet bowl or perform other service that requires
keeping the ush ball open without running water, locate the
Service Mode switch at the back left side of the seat mounting
bracket. Slide the switch to the right. (On some models the
Service Switch is a toggle type that’s located on the check valve
of the toilet. It can be reached behind the left side of the toilet
bowl. See page 11 for location.) Press the toilet’s Flush switch
until the ush ball opens, then release it to keep the ush ball
open. Perform the service operation. To close the ush ball and
return to Normal operation, slide the Service Mode switch to the
left.
Switch behind seat
® Bar Keepers Friend is a registered trademark of SerVaas Laboratories Inc.
® Clorox, Pine-Sol and Soft Scrub are registered trademarks of The Clorox Co.
® Comet is a registered trademark of Prestige Brands International.
® Drano is a registered trademark of S.C. Johnson & Son Inc.
® Pam is a registered trademark of ConAgra Foods.
® Sani-Flush is a registered trademark of Reckitt Benckiser Inc.
® Teon is a registered trademark of DuPont Co.
® WD-40 is a registered trademark of WD-40 Company.