Filter
Top Products
14
4800 SERIES VACUFLUSH TOILETS
back
OVER-TRAVEL CONDITION
Slide cam switch down.
front back front
UNDER-TRAVEL CONDITION
Slide cam switch up.
TROUBLESHOOTING GUIDE (cont’d)
REMOVING TOILET FROM FLOOR
1. Turn off water and electrical power to
toilet.
2. Remove water inlet hose from toilet.
3. Remove toilet from oor and turn it upside down.
MAKE SURE POWER WIRES REMAIN SECURE.
TO CORRECT PROBLEMS 6b, 9a and 12c:
4. Loosen cam switch mounting screws with 3/32-
inch hex tool and 1/4-inch box-end wrench. Slide
cam switch up or down (see illustrations below)
depending on ush ball position.
5. Tighten cam switch mounting screws, apply
electrical power and check adjustment. Repeat as
necessary.
6. After cam switch and ush ball are properly
positioned, connect water line and reinstall toilet.
Adjusting cam switch/flush ball
alignment
The ush ball should be properly positioned so that
the “A” and “B” distances are equal (see illustration at
right). If the ush ball becomes misaligned (resulting in
water leaking from bowl or other ushing problems),
follow instructions below to resolve problem.