Filter
Top Products
Unscrew measuring cap from
Fill measuring cap with solution
Fill remaining solution reser-
back side of solution reservoir.
2
times
(approximately
4
oz)
voir with hot tap water.
and pour into clean water tank.
Replace cap.
NOTE:
Use only Dirt Devil"
Carpet
&
Rug Shampoo. Using
other cleaning solutions may
cause excessive foaming.
kcessive foam will cause the
float to shut off the vacuum pre-
maturely. Using other cleaning
solutions
will voidyour wanan@
Place bottom of solution
Plug cord into electrical
NOTE:
Never leave unit mat-
reservoir into cleaner and
outlet. Step onto handle
tended with power on. Turn
rotate top into position until
release pedal to put into
OFF
when empiying and filing
the lever snaps into place.
cleaning position.
reservoir. Do NOT oversatu-
rate the carpet. Turn power
switch to the "on" position.
IMPORTANT:
FOR BEST CLEANING RESULTS USE A STEADY, MODERATE,
FORWARD AND BACKWARD MOTION. While depressing solution spray trig-
ger, pull unit in backward motion. Release trigger and push unit forward in
same path to remove dirty water and solution from carpet. (For heavily soiled
areas, repeat if necessary)(See page
8).
IMPORTANT:
IF THE SOUND OF THE
MOTOR CHANGES TO A HIGH PITCH, THIS INDICATES THE DIRTY WATER
TANK IS FULL AND MUST BE EMPTIED. A VISUAL INDICATOR IS WHEN THE
BLUE FLOAT HAS RISEN TO THE TOP OF THE DIRTY WATER TANK.