Filter
Top Products
REMOTE CONTROL USUAGE
The corner wall mounted electric fireplace is supplied with a radio frequency remote control.
This remote control has a range of approximately 50 feet (15.25m), it does not have to be
pointed at the fireplace and can pass through most obstacles (including walls). It is supplied
with one of 243 independent frequencies to prevent interference with other units. The
frequency designation is indicated on the back of the transmitter.
A. Remote Control Initialization
This procedure is required every time there is a loss
of power to the remote control in the fireplace.
(i.e. power failure, breaker tripped, main power switch
is turned off)
1. Ensure that power is supplied through main
service panel.
2. Locate manual controls. (refer to FIGURE 13)
3. Activate main power switch, red indicator light 1
will flash.
4. Press and hold the heater control switch for five
seconds. The second red indictor light will flash.
5. Press ON button located on the remote control
transmitter (FIGURE 14). This will synchronize
the remote control transmitter and receiver.
B. Remote Control Usage
The remote control operates the fireplace levels
sequentially. The level is increased every time the
ON button on the transmitter is pressed. The
fireplace can be turned off at any point by pressing
the OFF button on the remote control transmitter.
Level 1: The flame effect is turned on and the first red
indicator light is activated.
Level 2: The flame effect remains on, the heater is
activated to the low heat setting, and the first and
second red indicator lights are activated.
Level 3: The flame effect remains on, the heater is
set to the high heat setting, and all three red indicator
lights are activated.
9
FIGURE 14
Manual
Selection
Switch
Main
Power
Switch
Level 3 Indicator
Level 2 Indicator
Level 1 Indicator
FIGURE 15