Filter
Top Products
A
B
OPERATION
The controls are located inside the door panel on the lower side of the corner wall mounted
electric fireplace. (FIGURE 13)
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to all unit functions (heater/flame)
B. MAIN SELECTION SWITCH
To choose between flame effect setting, flame effect with low heat setting, and flame effect
with high heat setting.
C. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the thermostat control
clockwise all the way to turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in
this position to maintain the room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will turn on.
RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic cut out will turn the heater off and it will not come
back on without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF
and waiting 5 minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex customer service
at 1-888-DIMPLEX (1-888-346-7539).
NOTE
The heater may emit a slight, harmless odor when first used. This odor is a normal condition
caused by initial heating of internal heater parts and will not occur again.
8
C
FIGURE 13