Filter
Top Products
11
There is one (1) bulb under the top panel for generating the interior
light and two (2) bulbs under the log set which generate the ames and
embers.
Tool Requirements: Slot screwdriver
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce the number
of times you need to open the unit to replace light bulbs.
Upper Light Bulb Requirements
Quantity of one (1) 15 Watt candelabra E12 small base 120 Volt.
Do not exceed 15 Watts.
Upper Bulb Replacement
1. Remove the two (2) screws at the upper corners of the back panel.
Lift the back end of the top to clear the brackets and pull back. Lift
top carefully, and place to the side of the stove (Figure 5).
Caution should be taken as the top mounting brackets may
scratch the nish.
2. Remove the burnt bulb by pushing in and turning counter-clockwise.
3. Replace the upper light bulb.
4. Reassemble in the reverse order as above.
Lower Light Bulb Requirements
Quantity of three (3) 35 Watt Halogen Quartz lamps, 120 Volt, G9
base.
Do not exceed 35 Watts per bulb.
Lower Bulb Replacement
1. Gently place stove on its back on a at surface.
2. Remove thermostat knob.
3. Remove the heater cover retaining screws located on the bottom of
the stove (Figure 6) and lower heater and light assembly out onto
the oor.