Filter
Top Products
Step-by-step installation instructions.
10
Sanitizing Procedures
To complete the installation, do the following sanitizing procedures.
Care is taken at the factory to keep your water softener clean and sanitary. Materials used to make the softener
will not infect or contaminate your water supply and will not cause bacteria to form or grow. However, during
shipping, storage, installing and operating, bacteria could get into the softener. For this reason, sanitizing as
follows is suggested when installing.
NOTE: Sanitizing is recommended by the Water Quality Association for disinfecting.
Be sure to complete all installation steps, including timer programming.
Pour about 3/4 oz. of common 5.25% household bleach (Clorox, Linco, Bo Peep, White Sail, Eagle, etc.)
into the
brinewell
. Refer to illustration on page 6.
IMPORTANT:
Press and hold for 3 seconds the faceplate
TOUCH/HOLD
button to start an immediate
regeneration.
Recharge Now
begins to flash in the display. The bleach is drawn into and through the
water softener
.
If after sanitization water from house faucet tastes salty or has a slight color, this is a preservative from the
resin tank. Turn on the cold soft water faucets and drain for a few minutes or until clear.
4
3
2
1
NOTE:
When the above sanitizing regeneration is over, your house
COLD
water supply is fully soft immediately.
However, your water heater is filled with hard water and as hot water is used, it will refill with soft water. When
all the hard water is replaced in the water heater, hot only and mixed hot and cold water will be fully soft. If you
want totally soft water immediately, after the above regeneration, drain the water heater until the water runs
cold.
WARNING:
If you do drain the water heater, use extreme care as the hot water could cause burns. Turn
the water heater off prior to draining.