Desa W32RO Indoor Fireplace User Manual


  Open as PDF
of 4
 
www.desatech.com
122075-01B
3
Top (#7)
Leg
Assemblies
1
1
/
4
" Screw
Figure 5 - Attaching Top to Leg and Header Assembly
Washer
Back of Top
Flush with
Back of Leg
Assembly
GAS FIREPLACE INSTALLATION
1. Fireplace should be fully assembled. See Assembling
Fireplace in replace owner’s manual.
2. Place mantel base close to installation location. See re-
place owner’s manual for installation clearances. Leave
enough room to insert replace from back of mantel.
3. Install gas line. See Connecting to Gas Supply in replace
owner’s manual. Remember to leave access to the gas
shutoff valve somewhere on the base or where it is ac-
cessible to the user.
4. Check for leaks. See Checking Gas Connections in re-
place owner’s manual.
5. Position replace inside mantel (see Figure 6). Carefully
position gas lines. Important: Use caution when position-
ing replace on base. Base may scratch easily. Make
sure replace is in proper position within mantel opening
before continuing with installation.
6. Fireplace with louver door: Lower bottom louver door.
Use two screws provided in hardware package and attach
replace to wooden base. Close louver door.
Fireplace with xed louver: Before installing logs or
burner assembly (see owner’s manual) remove screws
securing oor to assembly. Lift oor for access to bot-
tom of replace. Use two screws provided in replace
hardware package and attach replace base to wooden
base. Reinstall oor with screws removed previously.
7. Carefully push mantel and base into position against
wall.
ELECTRIC FIREPLACE INSTALLATION
This mantel can be used with DESA Heating, LLC's 32" Electric
Fireplace. Electric replaces install from the front of mantel.
To install electric replace see replace instruction manual.
Use caution when positioning replace on base. Base may
scratch easily.
MANTEL TOP ASSEMBLY
Place mantel top (#7) on mantel assembly. Align back of top
with back of sides. Using four 1
1
/
4
" screws with washers, place
two in each mantel side assembly (see Figure 5). With three
1
1
/
4
" screws with washers, attach top to header. Make sure
all pieces are aligned properly and tighten, leaving screws
slightly loose.
Figure 6 - Installing Fireplace
 previous