Filter
Top Products
www.desatech.com
124452-01A16
INSTALLATION
Continued
3. Place rear log on heater base behind the
metal burner. The bottom of the rear log
has recess areas on the left and right side
for the base to set into. Pull the rear log
forward until it touches the front log (see
Figure 17, page 15).
4. Place the left crossover log as shown
in Figure 18. The bottom of the log is
marked with a “L” for left. Match round
peg on left side of top of rear log with
round hole in bottom of left crossover.
Match square peg on left side of top of
front log with square hole in bottom of left
crossover log.
5. Place the center crossover log as shown in
Figure 19. The bottom of the log is marked
with a “C” for center. Match square peg
on center of rear log with square hole in
bottom of center crossover. Match round
peg on center of front log with round hole
in bottom of center crossover log.
6. Place the right crossover log as shown in
Figure 20. The bottom of the log is marked
with a “R” for right. Match square peg on
right side of rear log with square hole in
bottom of right crossover. Match round
peg on right side of front log with round
hole in bottom of right crossover log.
7. Add lava rock around base of heater if
desired. Do not place any lava rock on
logs or burner.
Left Crossover
Log
Figure 18 - Installing Left Crossover Log
Figure 19 - Installing Center Crossover
Log (VYS18 Series Shown)
Center
Crossover
Log
Figure 20 - Installing Left Crossover Log
Right
Crossover
Log