Filter
Top Products
®
14
901272
VENTED GAS LOGS
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
.
OPTIONAL REMOTE
OPERATION
Note:
All remote control accessories must
be purchased separately. Follow instruc-
tions included with the remote control.
1. After lighting, let pilot flame burn for
about one minute. Turn control knob
to ON position. Slide the selector switch
to the REMOTE position.
NOTE:
The
burner may light if hand-held remote
ON button was on when selector switch
was last turned off. You can now turn
the burner on and off with the hand-
held remote control unit.
IMPORTANT
: Do not leave the se-
lector switch in the REMOTE posi-
tion when the pilot is not lit. This will
drain the battery.
IMPORTANT:
Be sure to press the
ON/OFF buttons on the hand-held
remote control unit for up to 3 sec-
onds to assure proper operation.
GHRC Operation:
2. Press the ON/OFF button to turn the
burner on and off. When turning
burner off, the pilot will remain lit.
GWMS2 WALL
MOUNTED SWITCH
(OPTIONAL)
This wall switch works just like the con-
ventional light switch. Flip the switch up
for on and down for off.
Note:
Make sure that this switch is not in
a position to be mistaken for a light switch.
This may result in the log set being inad-
vertently turned on without the proper
precautions being taken. See installation
instructions on page 11 of this manual.
OPERATING
APPLIANCE
Continued
During the 2-3 hour appliance break-in
period, you may detect an odor from the
appliance as the various paints and com-
pounds used in the manufacturing of this
log set cure. This is a normal and tempo-
rary situation that is not cause for alarm.
However, you may want to provide extra
ventilation to the room during this time.
To ensure proper curing of the logs:
• Ignite a 2" flame and maintain it for 1
hour.
• Burn the logs in consecutive 1 hour pe-
riods raising the flame an additional
2" to full flame height for a total of
three hours.
CURING LOGS