Filter
Top Products
21
104323
OWNER’S MANUAL
BURNER FLAME PATTERN
Figure 42 shows a correct burner flame
pattern. Figure 43 shows an incorrect burner
flame pattern. The incorrect burner flame
pattern shows yellow tipping of the flame. It
also shows the flame higher than one inch
above the log.
Note:
When using the fireplace the first
time, the flame will be yellow for approxi-
mately one hour until the log cures.
NOTICE: Do not mistake orange
flames with yellow tipping. Dirt
or other fine particles enter the
fireplace and burn causing brief
patches of orange flame.
If burner flame pattern is incorrect, as shown
in Figure 43.
• turn fireplace off (see To Turn Off Gas to
Appliance, page 19)
•
see Troubleshooting, pages 22 through 24
Figure 42 - Correct Burner Flame Pattern
Figure 43 - Incorrect Burner Flame Pattern
WARNING: If yellow tipping
occurs, your fireplace could pro-
duce increased levels of carbon
monoxide. If burner flame pat-
tern shows yellow tipping, follow
instructions in column 3.
Figure 40 - Correct Pilot Flame Pattern
Pilot Burner
Thermocouple
Figure 41 - Incorrect Pilot Flame Pattern
Check pilot flame pattern and burner flame
patterns often.
PILOT FLAME PATTERN
Figure 40 shows a correct pilot flame pat-
tern. Figure 41 shows an incorrect pilot
flame pattern. The incorrect pilot flame is
not properly heating the thermocouple.
When the thermocouple cools, the heater
will shut down.
If pilot flame pattern is incorrect, as shown
in Figure 41.
• turn heater off (see To Turn Off Gas to
Appliance, page 19)
•
see Troubleshooting, pages 22 through 24
Pilot Burner
Thermocouple
INSPECTING
BURNERS
Yellow Tipping
Top of Flame About One
Inch Above Charred Area