Filter
Top Products
www.desatech.com
108795-01V12
Conduit Sleeve
T o Safety Circuit
Route Millivolt
Through Gas Line
T o Thermopile
Wires (Supplied)
Wall Switch
(Not Supplied)
(Back View)
IN
TH
TP
THTP
IN
OUT
O
F
F
P
I
L
O
T
O
N
Note: If any of the original wire
as supplied must be replaced,
use 18 AWG TYPE CL2 (UL)
105 C (25 ft. length MAXIMUM)
or equivalent.
INSTALLATION
Continued
Figure 14 - Wall Switch Wiring Diagram
Figure 15 - Installing Remote Receiver
(Shown from Rear of Mounting Bracket)
Receiver
Mounting Bracket
Plastic
Mounting
Clips
Figure 16 - Installing Battery in Receiver
Battery
Clip
9-Volt Battery
Receiver
Terminal
Wires
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL INSTALLATION
Note: If using optional wireless hand-held
remote control, the wall switch is no longer
operational.
Installing Receiver
1. Remove front refractory access panel by
lifting up and angling out of rebox open-
ing (see Figure 13, page 11) to expose
controls.
2. Disconnect wall switch wires from TH and
TH/TP terminals on control valve (see
Figure 14).
3. Install remote receiver unit onto mounting
bracket using two plastic mounting clips
(see Figure 15).
4. Connect wires to control circuit. Connect
white wire to terminal marked TH/TP on
control valve. Connect red wire to male
blade connector provided at open end of
safety circuit wiring (see Wiring Diagram,
page 22).
5. Locate battery clip mounted on back of
receiver (see Figure 16).
6. Slide 9-volt battery (not included) through
clip. Note: Only use alkaline battery.
7. Attach terminal wires to battery (see Fig-
ure 16).
8. Replace refractory brick access panel.