Filter
Top Products
www.desatech.com
116226-01C
30
TROUBLESHOOTING
Continued
WARNING: If you smell gas
• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
POSSIBLE CAUSE
1. Gas leak. See Warning statement
above
1. High or gusting winds
2. Low line pressure
3. Pilot is partially clogged
4. Inner vent pipe leaking exhaust gasses
into system
5. Glass too loose and air tight gasket leaks
in corners after usage
6. Bad thermopile or thermocouple
7. Improper vent cap installation
1. Gas leak. See Warning statement
above
2. Control valve defective
1. Gas leak. See Warning statement
above
1. Air holes at burner inlet blocked
2. Burner flame holes blocked
3. Improper venting or excessive blockage
4. Excessive amounts of embers and pan
material
OBSERVED PROBLEM
Fireplace produces unwanted odors
Fireplace shuts off in use
Gas odor even when control knob is in OFF
position
Gas odor during combustion
Dark residue on logs or inside of fireplace
REMEDY
1. Locate and correct all leaks (see Check-
ing Gas Connections, page 19)
1. Fireplace has been tested for up to
40mph winds. However, extreme condi
-
tions may occur. See Lighting Instruc
-
tions on page 23
2. Contact local propane/LP or natural gas
company
3. Clean pilot (see Cleaning and Mainte
-
nance, page 27)
4. Locate and correct all leaks (see Check-
ing Gas Connections, page 19)
5. Tighten glass
6. Replace faulty component
7. Check for proper installation and free
-
dom from debris or blockage
1. Locate and correct all leaks (see
Check-
ing Gas Connections, page 19)
2. Replace control valve
1. Locate and correct all leaks (see
Check-
ing Gas Connections, page 19)
1. Clean out air holes at burner inlets. Pe
-
riodically repeat as needed
2. Remove blockage or replace burner
3. Have the vent system inspected, includ
-
ing the termination cap. Remove any
restrictions or obstruction
4. Clear excess embers until a minimum
gap of 1/2" remains under the grate
TROUBLESHOOTING