Filter
Top Products
111640-01B
17
17
For more information, visit www.desatech.com
For more information, visit www.desatech.com
OPERATING HEATER
Manual Lighting Procedures
Optional Hand-Held Remote Operation
OPERATING HEATER
Continued
1. Follow steps 1 through 6 under Lighting Instructions,
page 16.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
steps 9 through 11 under Lighting Instructions, page 16.
MANUAL LIGHTING
PROCEDURE
Note:
Hand-held remote control accessories must be purchased
separately (see Accessories, page 26). Follow instructions in-
cluded with the remote control.
1. STOP! Read the safety information, page 15 column 2.
2. Make sure equipment shutoff valve is fully open.
3. Set selector switch in the OFF position.
WARNING: Burners will come on automatically
within one minute when the selector switch is in the
ON position after the pilot is lit.
O
F
F
P
I
L
O
T
O
N
L
O
I
H
REMOTE
OFF
ON
Figure 31 - Setting the Selector Switch, Control Knob, and
Flame Adjustment Knob for Remote Operation
Selector Switch in Remote Position
Control Knob in
On Position
Flame Adjustment
Knob
OPTIONAL HAND-HELD
REMOTE OPERATION
4. Follow steps 4 through 7 under Lighting Instructions on
page 16.
5. After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position.
6. Adjust flame adjustment knob anywhere between HI and LO.
7. Slide the selector switch to the REMOTE position (see Fig-
ure 31).
Note:
The burner may light if hand-held remote
was on when selector switch was last turned off. You can
now turn the burner on and off with the hand-held remote
control unit.
IMPORTANT:
Do not leave the selector switch in the RE-
MOTE or ON position when the pilot is not lit. This will
drain the battery.
Figure 32 - On/Off Hand-Held Remote Control Unit (CGHRCB)
Control Button
Turns Burners
On and Off
THERMOSTAT SERIES (MODEL CGHRCTB)
The hand-held remote can be operated using either the manual
mode (MANU) or thermostatic mode (AUTO) (see Figure 33,
page 18). To select Fahrenheit/Centigrade mode display, care-
fully press the ˚C/˚F mode button with the end of a paper clip or
similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons together to turn on
the hand-held remote control.
2. Press the MANU button to turn on the fireplace.
3. Press the POWER and LOCK buttons together to turn off
the fireplace.
ON/OFF SERIES (MODEL CGHRCB)
Hold the control button on the hand-held remote until burner
turns on. Hold the control button again until burner turns off
(see Figure 32).
TO LOCK press both buttons on hand-held remote control until
light stops flashing. Hand-held remote control is now locked. If
the fire is on it will be turned off automatically. In the locked
state, the light will not light up when any button is pressed.
TO UNLOCK press both buttons together on hand-held remote control
until the light stops flashing. The hand-held remote is now unlocked.
WARNING: Make sure the selector switch is in the
OFF position when you are away from home for long
periods of time. Heater will come on automatically
with selector switch in the ON position.