Filter
Top Products
www.desatech.com
112882-01B 17
INSTALLATION
Continued
Figure 21 - Connecting Wires
Control
Valve
White Wire
From Receiver
Red Wire From
Receiver
8. Install remote receiver into receiver bracket
using pads and push button clips provided
with receiver (see Figure 20).
9. Connect wires to control valve at the TPTH and
TH locations as shown in Figure 21. Note: Make
sure excess wire does not interfere with burner
or pilot.
10. If heater was removed from fireplace before
installation of remote accessory, see Installing
Heater Base Assembly on page 13 to reinstall
heater into fireplace. Test gas connection for
leaks (see Checking Gas Connections, pages
15 and 16).
11. If logs were removed from heater for install
remote accessory, replace logs (see
Installing
Logs, pages 18 and 19).
Figure 20 - Installing Remote Receiver
Push Button
Clips
Bracket
Battery
Clip
9-Volt
Battery
Terminal
Wires
Pad
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand-held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit. Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver behind receiver
bracket mounted on base assembly.
2. Locate the battery clip mounted on the back
of the receiver (see Figure 20).
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
Battery Cover
9-Volt
Battery
Terminal
Wires
Battery
Housing
Remote
Control
Unit
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCB
Series)
Figure 23 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCTB
Series)
Battery
Housing
9-Volt
Battery
Terminal
Wires
Battery
Cover
Remote
Control Unit