Filter
Top Products
www.desatech.com
116010-01C12
5. Remove three screws located at front of re-
box (see Figure 21).
6. Align bottom rail mounting holes with holes
at front of rebox and secure with screws
removed in step 5.
7. Place ash box in place. Replace center brick.
Figure 24 - Bi-Fold Glass Doors
Doors Fully Closed
Fireplace Front
Fireplace Front
Doors
Fully Opened
OPERATION AND
MAINTENANCE GUIDELINES
Glass doors are optional with the replace. When
fireplace is in operation, doors must be fully
opened or fully closed position only or a re hazard
may be created (see Figure 24).
A replace equipped with glass doors operates
much differently than a replace with an open
front. A replace with glass doors has a limited
amount of air for combustion.
Excessive heat within the replace can result if
too large a re is built or if combustion air gate is
not completely open. The following tips should
be followed to assure that both the replace and
glass door retain their beauty and function prop-
erly. Both the ue damper and glass doors must
be fully opened before starting re. This will
provide sufcient combustion air and maintain
safe temperatures in rebox.
Remove doors and slightly loosen lower pivot clips
and upper spring clips. Replace doors and fully close
them. Use 1/8" shims (any material) to level doors.
Once proper setting is achieved, carefully open doors
enough so that you can access spring clips with a phil-
lips screwdriver. Tighten screws. See Figure 23.
Figure 22 - Installing Bi-Fold Doors
Spring
Clip
Insert Pin
into Spring
Clip
Pivot
Hole
Insert
Bottom
Pivot Pin
into Hole
Fold Door
and Slide
Top Pins
Into Track
Figure 23 - Adjusting Bi-Fold Doors
Figure 21 - Installing Bottom Door Rail
Bottom
Door Rail
Ash Box
Center
Brick
Ring
Handle
Screws
GLASS DOOR
INSTALLATION
Continued
Spring clips have been installed but some adjust-
ments may be needed. If doors do not close properly
or do not appear straight, see Door Adjustment.
1. With bi-fold doors completely folded, insert
bottom pivot pin into pivot hole located near
bottom corner of front face opening and swing
door to vertical position making sure top pins
slide into door track. Door is installed when
top door pin snaps into spring clip.
2. Repeat step 1 for remaining door.
If you nd the doors do not close properly or do
not appear level or straight, proceed with section
on door adjustment,
Spring
Clip