Filter
Top Products
5
101813
ASSEMBLY
ASSEMBLING HEATER
Tools Required: Phillips screwdriver, 5/16" hex wrench, and slotted screwdriver
Removing Front Panel Of Heater
1. Remove two screws near bottom corners of front panel with Phillips screwdriver.
2. Pull bottom of front panel forward, then down (see Figure 2) .
Continued
Figure 2 - Removing Front Panel of Heater
Installing Log
Note:
For easier installation, lay heater on its back.
1. Remove log from inside top of heater. Discard protective packaging.
2. Attach ignitor cable to piezo ignitor (see Figure 3).
Piezo Ignitor
Ignitor Cable
Figure 3 - Attaching Ignitor Cable to Piezo Ignitor
3. With Phillips screwdriver, remove four screws holding screen in place. Remove
screen.
4. Gently slide log between log retaining brackets on deflector assembly (see Figure
4, page 6). The log should fit firmly against bottom of log retaining brackets.
5. Reattach screen using four screws removed in step 3.