Filter
Top Products
109889
For more information, visit www.desatech.com
For more information, visit www.desatech.com
4
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off the heater if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches,
batteries, or other sources to light heater.
THERMOSTATIC HEAT CONTROL
This heater has a thermostat sensing bulb and a control valve. This
results in the greatest heater comfort. This can also result in lower
gas bills.
PRODUCT FEATURES
ASSEMBLING HEATER
Removing Front Panel Of Heater
Installing Hood
Installing Log
Figure 2 - Removing Front Panel of Heater
ASSEMBLING HEATER
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
REMOVING FRONT PANEL OF HEATER
1. Remove two screws near bottom corners of front panel with
Phillips screwdriver.
2. Pull bottom of front panel forward, then down (see Figure 2).
INSTALLING HOOD
1. Remove hood from protective tray.
2. Locate 4 black sheet metal screws from hardware pack.
3. Place hood on deflector and line up holes (see Figure 3).
4. Secure hood to deflector with 4 black sheet metal screws.
Note:
Side of hood should be on the outside flange of deflector.
INSTALLING LOG
Note:
For easier installation, lay heater on its back.
1. With Phillips screwdriver, remove two screws holding screen
in place. Remove screen.
2. Remove log from inside of deflector. Discard protective
packaging.
3. Gently slide log between log retaining brackets on deflector
assembly (see Figure 3). The log should fit firmly against bot-
tom of log retaining brackets.
4. Reattach screen using two screws removed in step 1.
Figure 3 - Assembling Heater
Log
Retaining
Brackets
Burner
Shield
Screen
Front
Panel
Deflector
Log
Truss-
Head
Screw
Brass
Front Trim
Screw
Screw
Heater
Cabinet
Nut
Hood
Sheet
Metal
Screw
WARNING: Always have burner shield and screen
in place before operating heater. This prevents ex-
cessive temperatures on heater surfaces.
Failure to position the parts in accordance with these
diagrams or failure to use only parts specifically
approved with this heater may result in property
damage or personal injury.