Filter
Top Products
5
104975
OWNER’S MANUAL
OPERATION
Figure 3 - Flame-Out Control Reset
Button
WARNING: Review and un-
derstand the warnings in the
Safety Information
section. They
are needed to safely operate this
heater. Follow all local codes
when using this heater.
TO START HEATER
1. Follow all ventilation and safety infor-
mation.
2. Fill fuel tank with kerosene or No. 1
fuel oil.
3. Attach fuel cap.
4. Plug power cord of heater into standard
230 volt/50 hertz, grounded (earthed)
outlet. Use an extension cord if needed.
Use only a three-prong, grounded
(earthed) extension cord.
Extension Cord Wire Size Require-
ments
Up to 30.5 meters (100 feet) long, use
1.0 mm
2
(16 AWG) conductor
30.6 to 61 meters (101 to 200 feet) long,
use 1.5 mm
2
(14 AWG) conductor.
Push ON/OFF switch to ON and heater
should start. If heater does not start,
press flame-out control reset button
(see Figure 3).
TO STOP HEATER
Push ON/OFF switch to OFF.
TO RESTART HEATER
1. Wait 2 minutes after stopping heater.
2. Repeat steps under To Start Heater.
Flame-Out Control
Reset Button
ON/OFF Switch
STORING, TRANSPORTING, OR
SHIPPING
Note:
If shipping, transport companies re-
quire fuel tanks to be empty.
1. Drain fuel tank.
Note:
Some models have drain plug on
underside of fuel tank. If so, remove
drain plug to drain all fuel. If heater
does not have drain plug, drain fuel
through fuel cap opening. Be sure all
fuel is removed.
2. Replace drain plug if provided.
3. If any debris is noted in old fuel, add 1
or 2 quarts of clean kerosene to tank,
stir, and drain again. This will prevent
excess debris from clogging filters dur-
ing future use.
4. Replace fuel cap or drain plug. Prop-
erly dispose of old and dirty fuel. Check
with local automotive service stations
that recycle oil.
5. If storing, store heater in dry place.
Make sure storage place is free of dust
and corrosive fumes.
IMPORTANT:
Do not store kerosene over
summer months for use during next heating
season. Using old fuel could damage heater.
PREVENTATIVE
MAINTENANCE
SCHEDULE
Item
Fuel tank
Air output and
lint filters
Air intake
filter
Fuel filter
Spark plug
Fan blades
Motor
WARNING: Never service heater while
it is plugged in, operating, or hot. Severe
burns and electrical shock can occur.
How Often
Flush every 150-200 hours of op-
eration or as needed.
Replace every 500 hours of opera-
tion or once a year.
Wash and dry with soap and water
every 500 hours of operation or as
needed
Clean twice a heating season or as
needed.
Clean and regap every 600 hours
operation or replace as needed.
Clean every season or as needed.
Not required/permanently lubri-
cated
How To
See Storing, Transporting, or
Shipping
See Air Output, Air Intake, and
Lint Filters, page 7
See Air Output, Air Intake, and
Lint Filters, page 7
See Fuel Filter, page 8
See Spark Plug, page 8
See Fan, page 7