Filter
Top Products
www.desatech.com
123224-01A 3
7. Locate upper and lower foot rail brackets.
Lower Foot
Rail Brackets
Upper Foot
Rail Brackets
8. Position upper and lower foot rail brackets as shown. Fasten to
pillar using 2 screws (A) for each pillar.
9. Slide foot rail down over heater assembly. Position foot rail as
shown, and fasten to brackets with 1 bolt (B) and 1 nut (C) for
each pillar.
Foot Rail
Upper
Foot Rail
Bracket
Lower Foot
Rail Bracket
Bolt (B)
Nut (C)
Pillar
10. Slide top assembly into position as shown, making sure that grate
tabs engage slots on underside of reector. Fasten in place with
1 screw (A) through each pillar.
Top Assembly
Pillar
Fasten with
Screw (A)
11. Connect regulator to gas cylinder. Gas cylinder will set inside of
cabinet assembly.
12. Check for leaks. See Checking for Leaks in your owner's manual.
13. Hang table door panel from slots in burner support plate to cover
inside of heater.