Filter
Top Products
8
105985
VENT-FREE NATURAL GAS STOVE HEATER
SUN VALLEY STOVE COMPANY
For more information, visit www.desatech.com
INSTALLATION
Continued
Figure 6 - Laying Down Stove On Side
Front of
Stove Unit
Pallet Wood
Bolted to
Stove Body
Bottom
Top of Stove Unit
Front of
Stove Unit
Top of
Stove
Unit
Drop Cloth/
Blanket
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
Pallet
Wood
Bolt
Pallet
Wood
Bottom Of
Stove Unit
Front
Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and Door Attachment
Leg
Hole
Leg
Hole
Leg
Hole
Leg
Hole
Door Hinge Step
Bolt Hole
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Stove
Bottom
Hole
Front
Bottom Of
Stove Unit
STOVE CAVITY ASSEMBLY
1. Lift off corrugated box enclosing stove
body crating.
2. Remove all screws fastening the wood
frame enclosure. Spread wood frame open
and lift away from plastic-bagged stove
body. The bottom pieces of pallet wood
will remain bolted to the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see
Figure 5). Use an adjustable wrench or
a 10 mm socket. Remove six (6) bolts
and washers. Keep bolts and washers
to reattach back panel later.
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom
(4) - Legs (includes leg leveler bolts)
(1) - Bottom door
(1) - Top grate
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to at-
tach bottom components to stove body
(see Figure 6). Rest stove on drop cloth or
blanket to avoid scratching stove edges.
7. Remove remaining pallet wood attached
to bottom of stove body (see Figure 7).
Use an adjustable wrench to remove bolts.
Figure 5 - Removing Back Panel
Bolt
Product Identification
Label
Back Stove
Panel
CAUTION: Cast iron is brittle.
Do not overtighten bolts or
screws during assemlby.
8. Fasten each leg to stove with four (4)
M8 x 1.25 - 20mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figures 8 and 9). Use
an adjustable wrench or a 12mm socket.
9. Fasten stove bottom to stove with four
(4) M6 x 1 - 25mm bolts. Use a flat
washer and lock washer with each bolt.
Tighten bolts into threaded holes on
stove body (see Figures 8 and 10). Use
an adjustable wrench or a 10mm socket.