Filter
Top Products
www.desatech.com
111347-01E
16
INSTALLATION
Continued
Figure 19 - Left and Right Front Log
Placement (Variable Manually-Controlled
Models)
Figure 20 - Control Cover Log Placement
(Variable Manually-Controlled Models)
Left Front
Log
Right
Front Log
Cover Log
Crossover
Log
Thermostat Models (CDL)
1. Place rear log on 2 pins on rear brackets (see
Figure 21).
2. Place front log on grate fingers and over pins
of rear log as shown in see Figure 21.
3. Place control cover log onto two pins on front
log assuring the cover log seats into cutout
section of front log (see Figure 22).
4. Place crossover log on pins on rear and middle
log (see Figure 22).
Figure 21 - Front and Rear Log
Placement (Thermostat Models)
Figure 22 - Front Log Placement
(Thermostat Models)
Rear and
Middle Log
Front Log
Cover
Log
Crossover
Log
OPERATING HEATER
MANUALLY-CONTROLLED
MODELS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow
these instructions exactly, a fire
or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier
from a neighborʼs phone. Follow the
gas supplierʼs instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand, donʼt
try to repair it, call a qualified service tech
-
nician or gas supplier. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.