Filter
Top Products
www.desatech.com
119526-01A12
Mantel Clearances for Built-In
Installation
If placing mantel above built-in replace, you must
meet minimum clearance between mantel shelf and
top of replace opening.
NOTICE: If your installation does
not meet the minimum clear-
ances shown, you must do one
of the following:
• raise the mantel to an accept-
able height
• remove the mantel
NOTICE: Surface temperatures
of adjacent walls and mantels
become hot during operation.
Walls and mantels above the
rebox may become hot to the
touch. If installed properly,
these temperatures meet the
requirement of the national
product standard. Follow all
minimum clearances shown in
this manual.
13. Attach replace to wall studs using nails or
wood screws through holes in nailing ange
(see Figure 16).
14. Check all gas connections for leaks. See
Checking Gas Connections, page 16.
15. Install trim after nal nishing and/or painting
of wall (see Figure 7, page 9).
Figure 16 - Attaching Fireplace to Wall
Studs
Nailing Flanges
Nails or Wood
Screws
Shield
Screw
Support Bracket
Firebox
Wrapper
Power
Cord
Figure 15 - Installing Shield to Support
Bracket
INSTALLATION
Continued